Week 8(Hardware Testing)

-
So , recently i able manage to construct my circuit on breadboard.The circuit running perfectly , I have measure output that i have amplified using darlington pair.But the only problem is the circuit cannot be tested using on the lab, Due to limitation of MCO.

Here is the construct circuit on breadboard.

Comments

Post a Comment

Popular posts from this blog

ERROR!![COMSOL]

-
Image
I've been trying to fix these error , maybe need to change value for mesh and variable , i will able update the solver on the next post , thanks. error: Undefined variable. - Variable: material.sigma12 - Geometry: geom1 - Domain: 3 Failed to evaluate variable. - Variable: comp1.mf.sigmaxy - Defined as: material.sigma12 Failed to evaluate variable. - Variable: comp1.mf.Jix - Defined as: ((comp1.mf.Ey*comp1.mf.sigmaxy)+(comp1.mf.sigmaxx*comp1.mf.Ex))+(comp1.mf.Ez*comp1.mf.sigmaxz) Failed to evaluate variable. - Variable: comp1.mf.Jx - Defined as: comp1.mf.Jix+comp1.mf.Jdx Failed to evaluate expression. - Expression: d((comp1.mf.d*(-comp1.mf.Hx*comp1.mf.testcurlAx-comp1.mf.Hy*comp1.mf.testcurlAy-comp1.mf.Hz*comp1.mf.testcurlAz+comp1.mf.Jx*test(comp1.mf.Adepx)+comp1.mf.Jy*test(comp1.mf.Adepy)+comp1.mf.Jz*test(comp1.mf.Adepz)))*(dvol),{test@6})
Read more

ERROR!!_PART2_[COMSOL]

-
Image
So , i have decided to change value of boundary condition mesh minimum element size , plate mesh size , because last week i have error due to element size , so , i change the value from 0.5 element size to , 0.1 and boundary conditions mesh from 0.38 to 0.2 , figure below ... Figure 1 : Plate mesh size Figure 2 : Boundary conditions mesh Figure 3 :Add new material Then after i change the value and add new material , it display new error and before the error begin , i encounter long time to compute the study.. It takes about 12 hours to complete , but at the end , it display the error says .. Figure 4:Failed to find solution , out of memory.. I hope on the next post , i will about my next step to solve this problem , thanks
Read more

Week 10-Troubleshoot [No graph display]

-
Image
       On this week , I try to re-do the simulation by changing materials that may affected result which generate no output.I also try change the size of minimum element size since I assume the minimum value of mesh may be affected of no magnetic flux numb. Figure 1:Plate mesh size changing to 0.1 , default is infinite.                                  Figure 2:Boundary condition mesh size change to 0.2, default is infinite.                                                                     Figure 3:Error found due to limitation geometry sizes.
Read more